I am designing a 4 layer PCB using Easy PC version 5. Is it possible to use blind vias (e.g. from layer TOP to layer INNER 1) or buried vias (e.g. from layer INNER 1 to layer INNER 2)? The users manual is not very clear on this subject. My current design uses TOP as Vcc, INNER 1 and INNER 2 as signal layers and BOTTOM as ground layer
Also, a minor point that does confuse users. Number One provides support for the current version, and the immediately preceding release, except for obvious things like bug fixes that wouldn't be done except on the current version. That means that at the moment, versions 9 and 10 are supported. Version 5 is getting on for 6 years old at present, and is much too long in the tooth!
blind/burried vias
Posted - 21 May 2007 : 02:48:41
