|
PeteJG
United Kingdom
51 Posts |
 Posted - 03 Sep 2015 : 10:28:48
|
I have used the Component Wizard many times, very successfully, until recently ...
I recently had to make a connector where the PCB footprint had 3 pads but the schematic had only 2. This was because the PCB footprint had a lug hole which was showing up as a pad and I couldn't see any options to change it to a plain hole. The Component Wizard wouldn't accept the different pin/pad qtys into the same component so I used the New Item option instead, which reported that it would marry the two as best it could, and it did.
Now, when I go back to the wizard to make another new component, it's ignoring what I type into the Component Pins entry on the Details page and only offering me 2pin options on the next (Schematic Symbol) page.
Has anyone seen this before? |
|
Component Wizard broken?
