All Forums  Help For Easy-PC Users  Manufacturing Outputs  slotted pads affects drill data

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize: 640 x 480 800 x 600 1024 x 768 1280 x 1024 UserName: Password: Format Mode: Basic  Help  Prompt  Format: Font Andale Mono Arial Arial Black Book Antiqua Century Gothic Comic Sans MS Courier New Georgia Impact Lucida Console Script MT Bold Stencil Tahoma Times New Roman Trebuchet MS Verdana   Size 1 2 3 4 5 6   Color Black Red Yellow Pink Green Orange Purple Blue Beige Brown Teal Navy Maroon LimeGreen Message: * HTML is OFF * Forum Code is ON Smilies [quote][i]Originally posted by Boris[/i] [br]I have a layout with approximately 4000 holoes in it and 12 slots. There are 25 x 81 pin BGA pads and a load of resistors on the board. When the drill data was created there were only the BGA holes shown and the non-plated holes. It is worthy of note that the drill table had the correct hole count and the drill ident drawing showed all the hole locations but they would not appear in the drill file. I removed one BGA component at a time thinking I had hit the limit on holes for the program but to no avail. I then removed the 3 slotted components one at a time. There was no change until I removed the last slotted component and suddenly all the 'lost' holes appeared in the drill file. Please would someone take a look at this phenomenon. Many thanks, Boris. [/quote]   Check here to include your profile signature. Check here to subscribe to this topic.