Number One Systems Forum

All Forums

Help For Easy-PC Users

Manufacturing Outputs

slotted pads affects drill data

Author

Topic

Boris

United Kingdom
34 Posts

Posted - 30 Apr 2009 : 17:36:19

I have a layout with approximately 4000 holoes in it and 12 slots.
There are 25 x 81 pin BGA pads and a load of resistors on the board. When the drill data was created there were only the BGA holes shown and the non-plated holes.

It is worthy of note that the drill table had the correct hole count and the drill ident drawing showed all the hole locations but they would not appear in the drill file.

I removed one BGA component at a time thinking I had hit the limit on holes for the program but to no avail.
I then removed the 3 slotted components one at a time. There was no change until I removed the last slotted component and suddenly all the 'lost' holes appeared in the drill file.

Please would someone take a look at this phenomenon.

Many thanks,

Boris.

Peter Johnson

United Kingdom
498 Posts

Posted - 01 May 2009 : 11:33:18

Please drop an email to support letting us know the version you're currently using, and including a copy of the offending file. It's not a currently known issue, so we'll need some data showing the problem to be able to investigate. Thanks.

Topic