All Forums
 Help For Easy-PC Users
 PCB Layout
 Custom Resist

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
AndyB Posted - 06 Dec 2011 : 11:15:21
I am having problems setting up a custom resist layer.
The component has a large pad and I would like to expose two small rectangle areas for copper and paste.
I have tried many ways but cannot seem to crack this.
Has anybody written a procedure to produce something like this.
Thanks
2   L A T E S T    R E P L I E S    (Newest First)
AndyB Posted - 06 Dec 2011 : 15:54:23
Thank you very much edrees.
edrees Posted - 06 Dec 2011 : 12:03:58
Make the component out of the two pads ("small rectangular areas") and add a closed copper shape ("large pad") as required. The two pads will have paste and no solder resist, the rectangular area will be covered with solder resist (apart from the pads area). The two pads can be electrically connected together in the component editor. Hope this helps.