All Forums
 Help For Easy-PC Users
 PCB Layout
 blind/burried vias

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
mta Posted - 21 May 2007 : 02:48:41
I am designing a 4 layer PCB using Easy PC version 5.
Is it possible to use blind vias (e.g. from layer TOP to layer INNER 1) or buried vias (e.g. from layer INNER 1 to layer INNER 2)?
The users manual is not very clear on this subject.
My current design uses TOP as Vcc, INNER 1 and INNER 2 as signal layers and BOTTOM as ground layer

Many thanks
3   L A T E S T    R E P L I E S    (Newest First)
Peter Johnson Posted - 21 May 2007 : 08:18:36
Also, a minor point that does confuse users. Number One provides support for the current version, and the immediately preceding release, except for obvious things like bug fixes that wouldn't be done except on the current version. That means that at the moment, versions 9 and 10 are supported.
Version 5 is getting on for 6 years old at present, and is much too long in the tooth!
mta Posted - 21 May 2007 : 06:16:59
Many thanks.
I guess I will have to consider an upgrade.
Iain Wilkie Posted - 21 May 2007 : 05:38:30
You need Version 10 to do blind/buried vias.

Iain