All Forums
 Help For Easy-PC Users
 Libraries and Components
 Component editing bug in 13.0.5

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
mpfj Posted - 12 Jan 2010 : 15:57:09
Just noticed the following problem having just updated to 13.0.5.

I have a socket with SM pads and a couple of locating holes. I was wanting to change the hole to now be plated. So I edit the existing component, edit the hole properties and check "Plated". Save. Close.

Now if I reload the same component, no changes have been made !!

I then tried to change the hole size. The hole did change size but, again, after a save / close / reload, no changes were made.

I then installed 13.0.4 again, and tried both of the above. Works fine !!

I'm not sure if it's a problem particular to our libraries, but I did try 3 different components just to make sure and they all exhibited the same problem.

Regards
Mark

Hear the thunder, feel the lightning.
4   L A T E S T    R E P L I E S    (Newest First)
mpfj Posted - 21 Jan 2010 : 15:15:25
quote:
Originally posted by Peter Johnson

I've had a look at this, and what is happening is that you are making the changes directly to the pad.

Correct ... but this has always worked. Is there any reason why it's now changed on 13.0.5 ??

Mark

Hear the thunder, feel the lightning.
Peter Johnson Posted - 20 Jan 2010 : 15:55:51
I've had a look at this, and what is happening is that you are making the changes directly to the pad. If you go to [Settings], [Design Technology] and edit the pad style, then it works. alternatively create a different pad style, and edit the pad to use the different style. It's when there are local variations on the pad that it's discarding them during saving.
mpfj Posted - 12 Jan 2010 : 19:34:16
quote:
Originally posted by shadders

Have you tried a new design without any components added or in the parts store ?.


This is with no project loaded ... just using the library manager.

Hear the thunder, feel the lightning.
shadders Posted - 12 Jan 2010 : 17:23:17
Hi,

Not sure about this, but if the component is already on the board the place component may use the existing component if it exists.

Have you tried a new design without any components added or in the parts store ?.

Regards,

Richard.