All Forums  Help For Easy-PC Users  Libraries and Components  Component Wizard broken?

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize: 640 x 480 800 x 600 1024 x 768 1280 x 1024 UserName: Password: Format Mode: Basic  Help  Prompt  Format: Font Andale Mono Arial Arial Black Book Antiqua Century Gothic Comic Sans MS Courier New Georgia Impact Lucida Console Script MT Bold Stencil Tahoma Times New Roman Trebuchet MS Verdana   Size 1 2 3 4 5 6   Color Black Red Yellow Pink Green Orange Purple Blue Beige Brown Teal Navy Maroon LimeGreen Message: * HTML is OFF * Forum Code is ON Smilies [quote][i]Originally posted by PeteJG[/i] [br]I have used the Component Wizard many times, very successfully, until recently ... I recently had to make a connector where the PCB footprint had 3 pads but the schematic had only 2. This was because the PCB footprint had a lug hole which was showing up as a pad and I couldn't see any options to change it to a plain hole. The Component Wizard wouldn't accept the different pin/pad qtys into the same component so I used the New Item option instead, which reported that it would marry the two as best it could, and it did. Now, when I go back to the wizard to make another new component, it's ignoring what I type into the Component Pins entry on the Details page and only offering me 2pin options on the next (Schematic Symbol) page. Has anyone seen this before? [/quote]   Check here to include your profile signature. Check here to subscribe to this topic.