Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 Help For Easy-PC Users
 PCB Layout
 Step and Repeat
Author Previous Topic Topic Next Topic  

AndyB

United Kingdom
208 Posts
Posted - 28 Apr 2011 :  20:17:13  Show Profile  Reply with Quote
I have not produced a step and repeat board before. Is there a standard gap between the boards?
Thanks

Iain Wilkie

United Kingdom
1016 Posts
Posted - 28 Apr 2011 :  22:53:06  Show Profile  Visit Iain Wilkie's Homepage  Reply with Quote
Never used this either ... normally the PCB manufacturer does it anyway..... however the normal sized router is 2mm
Go to Top of Page

AndyB

United Kingdom
208 Posts
Posted - 29 Apr 2011 :  14:39:30  Show Profile  Reply with Quote
Thanks
Go to Top of Page

edrees

United Kingdom
779 Posts
Posted - 29 Apr 2011 :  15:07:12  Show Profile  Visit edrees's Homepage  Reply with Quote
Depend on method of breakout. For cost effectiveness, some panels may be "V-Scored", so no gap is required. As Iain says, discuss it with your pcb supplier. If he is going to arrange the photoplotting, he can arrange the step-and-repeat too!
Go to Top of Page
  Previous Topic Topic Next Topic  
Jump To: