|
Boris
United Kingdom
34 Posts |
 Posted - 08 Apr 2009 : 15:52:36
|
I am not sure whether this should be in the pCB section or in here.
I had to do a layout from an old design and I used all current components, routed them out and reverse engineered it.
The schematic did not have the components in a sensible position as claimed and no nets were shown, (Ihave done this before and it has worked a treat, but it wasn't in Version 12).
When I move a symbol all the nets show until I put it down and they vanish again.
Please can anyone tell me what I am doing wrong or is there a switch somewhere which shows the nets. I can't seem to find anything anywhere.
Many thanks,
Boris |
|
Reverse Engineering
