|
gaztech46
United Kingdom
29 Posts |
 Posted - 24 May 2019 : 11:52:51
|
Hi,
I must be doing something very wrong...
I designed a Schematic, converted it to a PCB, fully routed it and all "looks" perfectly fine. Everything is connected in the right place and the board looks good. However, when I run a DRC check I get "Cm B" errors on EVERY component!
When on a PCB, how do you tell if the component is mounted on the bottom side of the PCB (could be that I guess as I may have used FLIP whilst placing components as flip doesn't do the same as it does on the schematic design!) ? Does the colour of the component change to green when you do this? I need to find out why the DRC check is doing this.
It's really confusing. Can anyone help?
Thanks. :) |
|
Cm B Errors on every conmponent
