All Forums
 Help For Easy-PC Users
 PCB Layout
 Non–masked border inside board outline?

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
Chris55000 Posted - 01 Jul 2022 : 18:38:44
Is there a method where I can leave about 2 cm. inside the physical board edge clear of the solder mask?

The 1967 Vintage BRC TV PCB I am trying to make for a vintage Radio Forum Member is made that way to allow a neater and visually more pleasing appearance!
2   L A T E S T    R E P L I E S    (Newest First)
Chris55000 Posted - 05 Jul 2022 : 10:12:07
Ah!

I didn't know that it was actually exactly the same principle as I couldn't find it in the User Guide!

Chris Williams

edrees Posted - 01 Jul 2022 : 22:15:37
Yes, -see the reply Iain and I gave you when you asked a very similar question regarding solder resist on your edge connector.