All Forums
 Help For Easy-PC Users
 Manufacturing Outputs
 Version 12 Cutouts

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
Iain Wilkie Posted - 02 Aug 2008 : 11:04:23
Presumably the ability to create "cutouts" in Version 12 now means that no additional routing layer is needed now as in the past ?
1   L A T E S T    R E P L I E S    (Newest First)
Peter Johnson Posted - 05 Aug 2008 : 10:29:51
Actually, you could do cutouts by nesting board outlines in earlier versions as well. What you couldn't do (that did require a dedicated milling layer to get round), was use slotted pads. Now in V12 you can, so special milling layers are a thing of the past.