All Forums  Help For Easy-PC Users  PCB Layout  Copper pour isolation

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize: 640 x 480 800 x 600 1024 x 768 1280 x 1024 UserName: Password: Format Mode: Basic  Help  Prompt  Format: Font Andale Mono Arial Arial Black Book Antiqua Century Gothic Comic Sans MS Courier New Georgia Impact Lucida Console Script MT Bold Stencil Tahoma Times New Roman Trebuchet MS Verdana   Size 1 2 3 4 5 6   Color Black Red Yellow Pink Green Orange Purple Blue Beige Brown Teal Navy Maroon LimeGreen Message: * HTML is OFF * Forum Code is ON Smilies [quote][i]Originally posted by John Baraclough[/i] [br]I have a small board with power connectors which I wanted to have six-spoke 25 thou isolation whilst the normal PTH components should have four-spoke 15 thou isolation. I created a pour within a pour and the inner one had the correct six-spoke isolation until the outer one was poured. Then additional thinner spokes appeared. I solved the problem by taking the inner pour to the edge of the board so that it wasn't surrounded by the outer one and they were separate entities. However, I wondered if there was a solution using a pour-keepout area and then creating the second pour inside it. I haven't tried this solution, but just wanted to ask how others do it. ------------------------------------------------------- Birthdays are good for you: the more you have, the longer you live ... [i]and I've had lots of them so I should know![/i] [/quote]   Check here to include your profile signature. Check here to subscribe to this topic.