All Forums
 Help For Easy-PC Users
 PCB Layout
 Over Ride DRC?

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
CY25 Posted - 07 Oct 2008 : 16:43:11
Is it possible to over ride a DRC error?

I have set the global clearance to 10 mils but one trace is 8 mils to two pads. There is no signal on those pads so I'm ok with it. Is there a way to flag those as ok so the errors don't keep coming back?

Thanks!
1   L A T E S T    R E P L I E S    (Newest First)
Peter Johnson Posted - 13 Oct 2008 : 18:54:47
In a nutshell, not at present. I don't believe that guard spacing allows negative figures, or that might be a fudge, but otherwise you'll just have to ignore them.