Number One Systems Forum

All Forums

PCB Layout

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:

UserName:

Password:

Format Mode:

Format:

Message:

* HTML is OFF
* Forum Code is ON

Check here to include your profile signature.
Check here to subscribe to this topic.

T O P I C R E V I E W
Benno	Posted - 27 Mar 2007 : 06:13:06 Hi I did a Design Rule Check on my unfinished PCB. For some reason the red lines (in my case showing NC) stay on the screen. I closed and reopened without effect. How can I solve that? Thanks
3 L A T E S T R E P L I E S (Newest First)
Peter Johnson	Posted - 26 Aug 2008 : 10:14:13 Thank you for these reports. I've passed them on to the programming team for further investigation.
pedro444	Posted - 24 Aug 2008 : 12:36:59 Hello all, V11.0.6 Two questions on DRC behaviour. If I run the DRC on a PCB to "delete errors" the errors are removed immediately, run the DRC on a schematic and I have to refresh the screen to remove any errors. Have a project with two or more schematics and run the DRC on the whole design. Each sheet gets its associated errors shown. To remove errors I have to do the "delete errors" on each individual schematic. The display errors applies to the project as a whole and the "delete errors" applies on a sheet by sheet basis.
DavidM	Posted - 27 Mar 2007 : 06:23:10 If you go to Tools, Design Rule Check, you should be able to click Delete Errors, then close the DRC dialog without clicking Check again. This will remove all existing DRC error markers in the design. Regards David David Manns Technical Support Number One Systems