All Forums
 Help For Easy-PC Users
 General Issues
 Step& Repeat Layer guides

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
Peki Posted - 15 Jul 2010 : 10:23:25
Hi,

I was just wondering- In home prototyping double sided board-.

Is it possible - when use step& repeat print to utilize more small pcb's on large board - to place guideline print (lines and Croshair circles) outside the Step&Repeate boards to guide positioning and aligning of top and bottom artwork?

Thanks

Petr

-pp-
1   L A T E S T    R E P L I E S    (Newest First)
Peter Johnson Posted - 15 Jul 2010 : 17:41:02
The short answer is no. The longer answer is similar, but there are a couple of quite nasty work arounds for this. Email support if you'd like full details.

Implementing step and repeat for only part of a design is quite a tricky thing to do, so it probably won't be implemented for some time.